![]() Holding the transfer tape taunt, apply decal to surface. Check that ALL the sections of the decal are attached to the transfer tape and have released from the paper backing.ģ. Carefully peel the paper backing off, while holding the transfer tape down with fingers. Lay transfer tape side down of a flat surface, with the paper backing side up. Clean surface very well and allow to dry.Ģ. The following glitter films are not recommended for use on car windows or for complex designs because they are a thinner film that may show wear sooner that expected: Silver Glitter, Blue Glitter, Gold Glitter, Gray Glitter.Īpplication instructions: Air temperature should be above 70☏ (21☌) with no humidity or moisture.ġ. ![]() Many bright, vivid colors to choose from, as well as glitter, ombre and printed patterns. Decals will ship in plain envelopes via the post office.Ĭolors: White and light colors are recommended for application on tinted car windows. Decals will last up to 6 years outdoors and almost forever indoors. Decals will permanently adhere to any smooth surface such as glass, metal or plastic. Then, the remaining pieces that make up the design are then covered in transfer tape, which is used to transfer the decal from the paper backing onto a surface, such as a car window. Add your own text!ĭecals: These decals (a.k.a vinyl stickers) are cut from a solid piece of high quality waterproof pressure sensitive vinyl with portions of vinyl that are not part of the design are removed. Please allow 48 hours (about 2 days) before taking it through a car wash.Four styles and two sizes to choose from. ![]() Repeat this until all of the decal pieces adhere to the surface. Slowly peal back the application tape again and ensure the decal adheres to the surface. Use a thumb or finger to apply pressure to the part that didn't adhere. If part of the decal sticks to the application tape STOP and lay the tape back down over the part that didn't stick to the surface. Starting at one corner slowly peal the clear application tape back. Use a hard-edged object like credit card or license to rub over the decal. Allow the middle to touch first, then lay the ends down. Once the decal touches the surface it will be impossible to reposition it without destroy the decal. DO NOT allow the decal to touch until you have it positioned correctly. ![]() Remove the paper backing slowly making sure the decal stays adhered to the transparent transfer tape.Ĭarefully position the decal to the desired area. This ensures that the surface is clean and dry ensuring the decal will stick properly. Continue repeating this until all of the decal adheres to the application tape.Ĭlean the desired area with rubbing alcohol. Starting at one corner slowly peal the clear application tape back about halfway. Using your thumb or finger rub over the application tape where it didn't adhere. If it does not stick to part of the decal STOP and lay the tape back down. ensure all of the decal sticks to the application tape. To apply one of our small decals to any smooth flat surface you can use the instructions below. During the winter this can be accomplished by applying the decal in a garage or by using a hair dryer to warm the surface.įor larger and more precise alignment use the instructions in the video above. Surface temperature should be above 50 degrease when applying a decal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |